Personal Vaporizer Instructions

Cleaning Your Device

STEP 1

Disassemble the device.

STEP 2

Use a soft wet toothbrush to gently clean all parts. Do not use anything other than water.

Turning Device On/Off

STEP 1

To turn Voodoo Personal Vaporizer ON or OFF, press the power button 5 times in rapid sequence.

STEP 2

LED light will blink rapidly for a second. Your device is now ready to use. When powered on, the LED light will glow blue when the button is held down. When turned off, the LED light will not glow when the button is held. It is recommended that you turn the device off prior to putting it in your pocket to prevent accidents.

Assembly and Disassembly-Battery with Top Loading Tank

STEP 1

Attach the Base Cartomizer to the Battery.

STEP 2

Attach the Coil Tube to the Base Cartomizer.

STEP 3

Attach the Drip Tip to the top of the Coil Tube Cartomizer.

STEP 4

Attach the Crystal Tank over the Cartomizer and the Drip Tip.

STEP 5

Attach the Mouthpiece to the Crystal Tank.

STEP 6

Your device is now assembled.

Charging Your Device

STEP 1

Screw the battery into the charger.

STEP 2

Connect the charger's USB plug into a dedicated USB port or wall charger.

STEP 3

Battery LED light will flash 3 times to indicate charging. Charger light will grow red while charging.

STEP 4

Charger light will turn green once fully charged.

Filling a Top Load Crystal Tank

STEP 1

Remove the Mouthpiece.

STEP 2

Lean the Voodoo Crystal Tank at a 45° to 60° angle and refill the Voodoo Crystal Tank along the wall slowly using your Voodoo E-Liquid dropper bottle with needle tip to avoid spilling.

STEP 3

Do not spill E-Liquid into the “center tube” as it will clog your Atomizer.

STEP 4

Fill the Voodoo Crystal Tank between 1.4ml and 2.0ml. Do not fill beyond the 2.0ml line.

STEP 5

Reattach the Mouthpiece and wipe away any spilled E-Liquid. Let E-Liquid soak in tank for 5 minutes before use.

STEP 6

Without pressing the power button, inhale through the device to saturate the stainless steel mesh (wick) with the E-Liquid. Your device is now primed and ready to use.

Adding Essential Oil

STEP 1

Unscrew the stainless steel tube from the gold Atomizer Base.

STEP 2

Place a few drops of oil into the Atomizer Base and make sure it saturates the fibers around the chamber. 

STEP 3

Reattach the stainless steel tube to the gold Atomizer Base.

STEP 4

Connect the Battery to the Atomizer Base.

STEP 5

Push the button for a few seconds at a time to warm the oil until it melts into the unit.

What if my Cartomizer isn't working with my Battery?

STEP 1

Empty the Crystal Tank and disassemble your device.

STEP 2

Connect the Base Cartomizer to the Battery.

STEP 3

Using a pen, push the open post until you feel it touching the center of the battery.

STEP 4

Remove the Drip Tip from the Coil Tube Cartomizer.

STEP 5

Connect the Coil Tube Cartomizer to the Base Cartomizer.

STEP 6

Add one small drop of E-Liquid to the Coil Tube. WARNING: Do not exceed one drop. Adding more than one drop may cause your device to fail.

STEP 7

Press and hold the power button. Listen closely and you should hear the sizzling of the E-Liquid.

Back to Top